The Bluetooth Dongle. Read below for details
If it’s one thing that continually amazes me is the impact Arduino & IoT are having on Amateur Radio. Things that were once complex pieces of electronics with a complex price tag are now commoditised and available for pennies.
When I first started, a CAT rig control interface could cost up to $200, particularly if on-brand. Taking a look on eBay now, you can find a heap of these Bluetooth Dongles that plug into the back of my FT-817 for generally around $12!
Unfortunately for me, the one that arrived is dead on arrival. It did give me an opportunity to pop the cover and see what is inside. there is not a lot to it at all! To the right of the LED in the picture is basically an AMS1117 3.3V regulated power circuit base, with an HC-05 Serial TTL to Bluetooth Module soldered on as a daughterboard. With only 5 pins in use – +ve, gnd, rx, tx, and LED state, very little needs to be done with these units other than connecting the cables at the right places!
My testing of this unit found that the HC05 board is defective. I have confirmed all power is going to the right places, and it is correctly wired, but unfortunately the unit does not broadcast a bluetooth device ID. This is the big catch when buying from eBay – you get what you pay for! lucky for me the seller is willing to send a replacement unit.
I think however I will eventually purchase one of the units made by K6VHF (His eBay store here). Its ridiculously more expensive, but I will get a unit that has been assembled and tested properly by someone familiar with the radios – and given I spent about an hour of my time today troubleshooting the defective one, with unknown quality of the replacement, that may be money well spent.
I’ll give an update when I have a working adaptor!
